Trying to remove tranny, I've pulled and pushed on that stupid clutch fork with no luck. It only moves about a inch.
Which is it? Push or pull? Any other tricks?
Which is it? Push or pull? Any other tricks?
Is there a certain angle I need the engine to be in to make it slide out easier?
yes you need 1991-1996 flywheel bolts
(8) 90011-PR7-000 BOLT (12MM)
Not bad about $4.00 ea.
Regards,
LarryB
Guess who's dumb? This guy!
All of that time pushing and pulling and heat stroke.... and what kept the transmission on? The stupid Flywheel Dust Shield. Not once did I read in anyones write up's to remove that!
Good news, transmission is dropped and rear main seal is replaced.
Bad news, the stock flywheel bolts are too long for my RPS Flywheel.
Hmm....