Jack contact points

There are two lift points on each side, where a metal bar is welded to the frame. One is behind the front wheel, the other is in front of the rear wheel. If you look beneath the car, you should be able to see them.
 
By the way, the floor is not capable of supporting weight. So don’t try and lift on anything other then the lift points as described.
 
So it looks like you cannot lift the entire front or back by placing the hydraulic floor jack under a central position, lifting up that end, and place jack stands at the two front or rear positions. Perhaps a 4-point lift is the best option.
 
There are a couple of stands that allow you to raise the car and then pull out the Jack. They are not cheap, about $200 per piece.
 
This is one example, the issue is getting under our cars as there is not a lot of space approximately 3 inches

The RennStand Jack Stand

 
This is one example, the issue is getting under our cars as there is not a lot of space approximately 3 inches

The RennStand Jack Stand

I've never seen that before, but its design makes sense. Thanks.
 
Back
Top