Search results

Acura NSX PART OUT FOR SALE: All plus shipping -Driver lower control arm $200 -Rear Control rod $100 -Each radio $25 ea INOP stereo fading issue SOLD {Willmanselectronics will rebuild for $200 (working radio valued near $1,000)} -Passenger side door handle outer * serviceable but scuffed...

Bump checkout new price

Could of been mine, i have mine taken out while im deployed every so Often.

I bought mine as an e5 with fairfield county bah, now as an O2E and deployed again, looking to sell the 91, and buy newer one.

Bump price reduced $26500

Bump, Car is moved To North Carolina, by myrtle beach.

not sure but you may want to check out Danbury Honda, they use to have a low profile roller setup. Not sure if they do anymore.

YEAR & MODEL (NSX or NSX-T):91 NSX FULL VIN #: JH4NA1156MT002373 CURRENT MILEAGE: 97000 COLOR (EXT/INT): Berlina Black/ Black TRANSMISSION: MT LOCATION OF VEHICLE (CITY/STATE): Tabor City, NC CONTACT VIA (E-mail, PM, phone number, etc.): [email protected] 910.653.5525 PRICE (MUST STATE A PRICE...

nsx did a few things wrong IMO, coming from a turbo buick i know turbo races are hard to do heads up. Anyway, the nsx was out of the throttle entirely until light was green shown by the bad eta. should have preloaded or invest in a launch controller. he was also bouncing off the rev limiter...

what size hot side a/r you running, with meth and those temps :eek: i would say that heat soak played a large factor, but this is the joy of F.I., remind you of that FD, I have been here with my cars. In my Z I had to run dei cry02 intake and intercooler sprayers, with c02 not with nitrous, I...

Are you still running a stock IAT sensors or an aftermarket one, also is the sensor before or after the nozzle

Yes. It is. Normally you look for 20 to 30 over ambient. Anything over 130 with methanol something ain't right especially at 10 psi

it should be able to take it provided you do not get detonation, Probably get head lift before the gasket blows.

its up to you, but full bore may not even need to be achieved by then. it only going to use what it can anything else is just in the tail pipe. He is right about not switching back, however this doesn't seem like your goal. Every motor is made differently. Even ones that are hand assembled...

Just be careful around DOT with 100% methanol, if they ask tell them its 50/50. Otherwise tell them its HAZMAT class ORM-D, some of them love to bust your stones, as it has a quite distinct smell. Otherwise you can get a good fine for transporting a Combustible liquid, and corrosive without...

m16 is 600cc

i had to go smaller, methanol can hydro-lock an engine for a split second, then it will fire once those exhaust valves open, its not too good. Depending on your system, you can change the line pressure to compensate. if you have a cheaper one, smaller nozzle is the only way to go. I'd start with...

just make sure on hot days you dont fill the tank up, methanol has an invisible flame. Ive seen this a couple of times with the Rx7 guys running out of the windshield washer bottle. And you dont want to run too rich below 11.2 with 100% methanol, you'll be changing plugs every couple thousand...

it will make your 11.8 tune go straight into the 10's as far as AFR, however methanol make power by timing. by running 100% your probably running something like 100 octane. without meth i run 16 degrees of timing, with 50/50 i am running somewhere around 21, with 100%, the AIT where a tad bit...

there are many inherent problems with running 100% methanol, namely safety as it boils at 148F. but that aside, you will lose a good amount of torque generated by the steam effect on the power stroke of the engine cycle leading to more torque. (Same principle that Steam engines were designed...

Advan rs. In Gunmetal

It has lock rings on it. I am not sure if it can be taken off while bumper is on the car. It was already off when I got the car

In October 2010, I purchased a totaled 91 NSX... It has been sitting in my garage as a side to a side project, it wasn't until recently I started to really dive into it. I knew I had the bodywork to do, and the obvious broken suspension pieces. I then became a member on prime and used the...

Z/BMW/ Subie/ silvia car meet I have been to a few of these when i Had my Z, usually pretty good, turns into a BBQ or a ride to hooters in which they usually take up the parking lot, first time the NSX will see the road since it was rolled over in 2010, LOVESNSX's NSX. Where: Sage Park [1591...