I have the prob with a loping at idle only, runs fine off idle. Based on a search of the board, dirty idle circut is probably the culprit. How do you clean it, is this a DIY job?
-
Protip: Profile posts are public! Use Conversations to message other members privately. Everyone can see the content of a profile post.
Cleaning Idle Circut?
- Thread starter Vegas Boy
- Start date
The procedure is in the issue before last one, you are a member of the NSXCA and get the NSX driver magazine right? :wink:
Sad to say but no, is there a link?
There is no link to the NSX Driver Mag. I have done a couple of searches here on prime and have not found a full procedure. I can only direct you to the on line manual, look over the info for the throttle body, EACV and fast idle valve. The passages to and from the EACV are what you need to give the most attention to.
THanks, will try it.
