• Protip: Profile posts are public! Use Conversations to message other members privately. Everyone can see the content of a profile post.

Exterior FS: Garage Kite Rear Under Cowl / diffuser

Status
Not open for further replies.
the fit over the valence. The inside part of the cowl is cut out so that it will fit perfectly over the current valence. I was told that to make it fit perfectly you have to remove the rear bumper, loosen the valence, install the cowl between the bumper and the valence and re tighten.

If that makes sence. The diffuser just attaches with supplied screws.

Here is a pic installed that I found.

http://www.nsxprime.com/photopost/data/500/122269987Rear5.jpg
 
Last edited:
Status
Not open for further replies.
Back
Top