remove the exterior window molding ?

[Raymond-honda]

I need your help .... how I can remove the ext. window molding without to crack the plastic clips ....

thanks for your help

Raymond

 

[BlackbirdXX]

Could you be more specific as to which window and which mldg.

 

[Raymond-honda]

see on the pic ( parts sheet ) the part number 11 / 14 left & right exterior door window molding

how I can get out the clips of the molding .... with a special tool ?

It seems this is very difficult ....

 

[davidf]

I've had these off a couple times. Other than the one screw in the front, I did use a really small screwdriver the get it off the clips. No it was'nt easy as I'd liked but you'll need to start at the back {opposite end of the screw} and as you get each clip unhooked hold upward pressure on the moulding so it does'nt snap back in place.

 

[Larry Bastanza]

I use 4 little screwdrivers.........

 

[davidf]

Opp's, Larry is correct. I was thinking about the inner piece. :redface:

 

[Raymond-honda]

ok, thanks for your help ... I will try it and I hope to remove the molding without to damage them.

 

[SFNMNSX]

Took these page pics from my '94 NSX bible.:wink:View attachment 99047View attachment 99048=DREW=

 

[Brooklynzson]

Took these page pics from my '94 NSX bible.:wink:View attachment 99047View attachment 99048=DREW=

Pics don't work...

 

[Old Guy]

Shawn to the rescue. See post #5 in the following thread.

http://www.nsxprime.com/forum/showthread.php/179834-Removing-interior-door-panel

 

[Brooklynzson]

Shawn to the rescue. See post #5 in the following thread.

http://www.nsxprime.com/forum/showthread.php/179834-Removing-interior-door-panel

Appreciate it.

 

[nikey22]

Appreciate it.

Why are you doing this job, is there a replacement molding part that you are putting in? Thanks.

 

[Brooklynzson]

Why are you doing this job, is there a replacement molding part that you are putting in? Thanks.

Gonna wrap my car soon :wink: