Trying to access the switch that activates the driver door and under dash courtesy light. I understand the switch is part of the door lock mechanism in the driver door. One of the searches I found said there was a visible piece of metal (I assume small prong - paperclip like) that is...
Car Information
Year: 1991
Type: NSX coupe
Transmission: 5-Speed
Exterior color: Black
Interior color: Black
Odometer: 130,000 mi
VIN: JH4NA1153MT002041
Price: 42,500
Car History
Title History: Current title is clean. No known branded title history...
Guys - need a little help. My LF brake hose has a pin hole leak. Iv'e looked in several on-line parts catalogs under break lines and can see the part but it is not listed. Starts at part "7" and I need something like a "2".
Any help?
Thanks,
Dew
I have owned a 91 NSX for 20 years and drive it every day 5 miles to work and 5 miles back; love it. I was really looking forward to the new NSX but the reports are not as good as I hoped. But it can be driven every day. So do you buy a 911 Carrera S for $50K less to tool around town in or do...
I need to replace the exterior black plastic B Pillar or garnish, as Acura calls it, behind the drivers widow. The manual says its accessible from the rear hatch. That just does not seem right. Looks like to me its accessed by removing the small interior piece just behind your left ear when...
Does anyone have one in good shape from a parted out car. The sun has ruined mine.
Part number: 72575-SL0-505ZC
Thanks,
Drew Altemara
[email protected]
Need to remove to see if I can get the door latch switch that signals door open or closed out.
Can this be removed with out removing window tract? Looks tight.
Thanks,
Drew
My outer rim of my stock steering wheel is getting pretty bad. You can find pretty good used ones on ebay, etc but general they have been in a wreck and the air bag has deployed. Should be relatively simple to transplant my air bag into a better used wheel. Any issues with this approach...
I can't seem to find the thread or DIY article that showed how to test the resistance of the coils to make sure they are good.
Can one of you point me in the right direction.
Thanks,
Drew
Became a member of the club over the weekend. Took about 4 hours and I have a 4 post lift in my garage which helps. This is for a 1991 NSX and I purchased the Science of Speed O2 sensors.
To get to the rear sensor I removed the shielding on the exhaust and manifold to get more room. Also...
Is it possible to switch the passenger side seat to the drivers side and move the seat controls and vice versa?
Have wear on drivers seat but not passenger side so trying to spread around.
Thanks,
Drew Altemara
91 NSX Manual
Been having problems with my starter and now it will not turn engine over. It whirls, bad sound though especially when cold, but for some reason will not engauge the fly wheel. It is not truning engine over; tries to but accessory belts barely move so it is not engauging fly wheel correctly...
Which is the correct switch for the switch that disables the starter unless the clutch is depressed. The parts diagram is confusing.
#25 35710-SE3-A01 SWITCH ASSY., CLUTCH (INHIBITER)
or
#27 36760-SM4-003 SWITCH ASSY., CLUTCH
I think it is #25 but what the heck does #27 do (disable cruse...
Any service recommendations in the Birmingham area; timing belt, water pump, clutch. Or do folks just go to Atlanta? If so who is recommended in the Atlanta area?
Appreciate,
Drew Altemara
Is the speed sensor that sits on top of the transmission housing accessed from the top or is it better to reach around from underneath? Looks like it is held on with one bolt that also holds the heat shield. Is that correct.
Regards,
Drew
Just a brief note.
I replaced the exhaust on my 91 NSX with a Dali Wishuponastar exhaust over the weekend. I drive the car daily and wanted something better sounding than the stock exhaust but not that much louder.
The exhaust was relatively inexpensive, was shipped promptly and was well...
I'm installing a Dali Wishuponastar exhaust on my 1991 NSX. I had to drill out the holes on the exhaust to get them to line up with the bolts that come from the catalytic converter. One of the bolts snapped off as I was tightening the nut and left the stud/bolt.
As the exhausted came with its...
For the life of me I cannot find the oil pressure sending unit (one that sends to the gauge) in the parts book. Which section of the parts book is it in?
Thanks,
Drew Altemara
What are the options for either a single or double DIN cut center console? SOS is out and does not have an ETA. Who else manufactures them? My head unit is bad and I want to go with an aftermarket stereo but need to solve the center console issue first.
Thanks,
Drew A
Could someone tell me the location of the coolant temp sensor is located that sends the signal to the ECU. Not the one for the gauge. I can't for the life of me find it on a parts diagram.
Thanks,
Drew Altemara
I swear but can't fine it in the forum or manual. Just dense I guess.
Where is the AC low pressure cut off switch located?
And shorting between the wires does it engauge or disenguage the compressor clutch with ignition on but engine not running?
Thanks. Sorry about the bad searching...
This is for a 1991 manual NSX. How do you remove the backup light switch? Is it screwed in or does it just pull out. I've seen reference that it is on a bracket but the only bracket I see is the one holding the connector.
Regards,
Drew Altemara
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.