Recent content by au-nsx

OEM Complete Airbox Intake Complete OEM Airbox, intake, tubes, everything! Removed from a 1995 NSX that had 45k miles. The only thing missing is one of the screws shown in the photo. Should be able to pick up at local hardware store. List Date: 3/30/2014 For more info, click here to view...

Science of Speed Center Console for aftermarket radio/navigation Brand New! Brand new, never used, Science of Speed Center Console. This console is designed to replace your factory console when you want to add an aftermarket radio and/or navigation. This cost $250 from SOS plus shipping. I am...

YEAR & MODEL (NSX or NSX-T): 1995 NSX-T FULL VIN #: JH4NA1184ST000371 CURRENT MILEAGE: 47,051 COLOR (EXT/INT): Black/Black TRANSMISSION: 5 speed Manual LOCATION OF VEHICLE (CITY/STATE): Tulsa, OK CONTACT VIA (E-mail, PM, phone number, etc.): [email protected] -- I can give you my cell...

Here is mine......

17/18 POLISHED TE37 WHEELS OK, here are the specs: Polished TE37 Wheels Front: 17 x 7.5 with a +44 offset (not including spacer) The spacers on the front measure 1/4" thick which equates to 6.35mm Rear: 18 x 9.5 with a +41 offset Left Front - Pretty clean, no curb rash, just a couple of...

Hello, wanting to buy a NSX-R style hood like http://www.scienceofspeed.com/products/exterior_performance_products/NSX/TAITEC/NSX-R_style_hood/ Let me know what you have.

Yeah, the best bet might be to go down to 255's as I really don't want coil overs. If the camber won't fix the problem. Looks like by switching to 255's from 265's that will reduce the width by -0.39" (based on general tire calculator math) which might make the largest and biggest...

Can the more (negative) camber simply be achieved by adjusting what is on the car from factory, no "camber kit" necessary?

Hey guys, need your help. Just purchased a set of Advan Model 5's from a fellow prime member. Wheels looked great and nice guy to work with. I got them mounted yesterday and the rear wheel/tires stick out too much in my opinion. Both me and the seller were on the same page before I purchased the...

Dave, thank you so much for taking the time to answer all of my questions! Looks like I will go ahead and change the oil, since I don't know the last time it has been changed. I will take a pick of the fuel reg. tonight to confirm which boost I have. Also, where is the best place to buy those GY...

100 views and nothing? Come on guys.......

Hey guys, I just purchased my 1995 NSX that has a Comptech Supercharger installed. The car runs great. But I wanted to make sure everything (fluids, belt, pulleys, bearings, etc) are in check. My questions are: 1. Which version of CTSC/Whipple do I have and what is the PSI of boost typical with...

Hey guys, I just purchased my NSX and the aluminum coolant tank has some stains on it (I assume from previous coolant spill?). I have tried just about everything, but can not remove the stains. Any ideas on what to use to remove them? Thanks

OK, last night, I installed my Bline CAI and had to remove the rear wheel, and......drum roll please...... it is stamped Rays Eng, Forged, Made in Japan, etc......so there you guys go. Good news for me. I didn't think the previous owner of this stellar NSX would install knock-offs. I hope to...

Hey all, I've got a 1995 NSX and was planning on getting some side skirts. I like the look of the "Stacy" skirts, but it seems everyone has them. I like the clean look of the DF 2002 Factory Style Skirts that SOS sells. My question is, how much lower to the ground are the skirts compared to my...