How to pop out bushings from rear beam?

[haveblue]

The one where the camber adjustment bolts attach to? Is there any specific direction that they need to pressed from?

 

[Larry Bastanza]

You need a special puller for this. Titanium Dave made a really nice puller, I think he may still have some. Works great for me, no damage, all good, and the tool he made also is used the insert the replacement bushing.

HTH,
LarryB

 

[nsxspdfreak]

You can also use two sections of pipe or possibly sockets with one being a diameter larger then the bushing and the other about the same size as the bushing but smaller than the bore hole in the beam. You'll also need a bolt to pass through the bushing and both pipe (sockets) sections plus 2 large washers and a nut. Place the pipe sections on either side of the bushing, pass the bolt and washer through it, secure it with a nut and washer on the other end and then tighten the bolt/nut. The bushing will press out into the larger diameter pipe (socket).