Hey Guys,
Just installing the SOS (Stage 1) Stereo Audiophile system and could use a little help.
I have installed the new door speakers (using the existing Bose wiring) and I am now trying to get the signal from my amplifier (in the trunk) to these speakers.
I have read that it is much easier to "terminate at the head unit" because running speaker wire through the doors is a pain. The wiring harness adpater I was sent from SOS (factory head unit to aftermarket amp) does not have any available wires to connect to or splice into for speakers (it appears to only have wires for +12V, Remote, Ground, Etc). This would mean that I would need to cut into the factory harness in my dash, which is something I am definitely trying to avoid.
I put a link to the wiring harness I purchased below. I purchased it because I am retaining my factory head unit.
http://www.scienceofspeed.com/produ...d/ProFormance_Audiophile/stereo_wire_harness/
So basically, how can I use my factory speaker wiring without having to cut wires off the harness?
Btw, I am (trying) to follow the SOS supplied instructions as well as the post found here on this forum by D'ecosse (with some really good pointers from SMYLDOC
http://www.nsxprime.com/forums/showthread.php?t=51961&highlight=audiophile&page=2
Just installing the SOS (Stage 1) Stereo Audiophile system and could use a little help.
I have installed the new door speakers (using the existing Bose wiring) and I am now trying to get the signal from my amplifier (in the trunk) to these speakers.
I have read that it is much easier to "terminate at the head unit" because running speaker wire through the doors is a pain. The wiring harness adpater I was sent from SOS (factory head unit to aftermarket amp) does not have any available wires to connect to or splice into for speakers (it appears to only have wires for +12V, Remote, Ground, Etc). This would mean that I would need to cut into the factory harness in my dash, which is something I am definitely trying to avoid.
I put a link to the wiring harness I purchased below. I purchased it because I am retaining my factory head unit.
http://www.scienceofspeed.com/produ...d/ProFormance_Audiophile/stereo_wire_harness/
So basically, how can I use my factory speaker wiring without having to cut wires off the harness?
Btw, I am (trying) to follow the SOS supplied instructions as well as the post found here on this forum by D'ecosse (with some really good pointers from SMYLDOC
http://www.nsxprime.com/forums/showthread.php?t=51961&highlight=audiophile&page=2