- Joined
- 22 August 2005
- Messages
- 21
So, I recently purchased my 91 NSX. I lowered it about 1.5" and when I took it in to get an alignment they told me that they could not get my passenger rear camber to come back to spec. The best they could get was about 2.5 degrees negative camber. They were able to get the drivers side really close. Anyway, I figured that my upper control arm must be bent. So, I ordered one. Looking at them side by side I wasn't sure my old one was bent. I put the new one on anyway and it wasn't. I can't see anything else that could be causing this. Does anyone else have any ideas???